About UsTechnologyInstructionOur ProductsContactNewsHome Page
CLAMPING TORQUE (Nm)
Clamping diam.68101216202532
Clamping force1525551152003506501000

CAN BE CLAMPED

Directly in the chuck, tools can be clamped, with smooth cylindrical shanks as well as tools with weldon shanks up to 20 mm.

OUR STATE OF THE ART TECHNOLOGY IS BUILT ON THE FOLLOWING:

The clamping actuation

A piston with a seal compresses the internal fluid.

Internal membrane with external ROMBOID form

The romboid form of the membrane gives up to 75% higher clamping forces compared with the traditional-cylindrical membrane.

Adjustment of the Axial Tool length via adjustment screw

Please note that this can only be done when tool is free from clamping pressure.
BALANCE QUALITIES
HSK A63G2.5 to 15.000
HSK A100G2.5 to 12.000
ISO 40G2.5 to 15.000
ISO 50G2.5 to 15.000
BT 40G2.5 to 15.000
BT 50G2.5 to 15.000
CAT 40G2.5 to 15.000
CAT 50G2.5 to 15.000

On request higher balancing qualities are available.


*In comparance with hydraulic tool holders of the world.